Cisco Cisco Aironet 350 Wireless Bridge 문제 해결 가이드
Preserving the Ability to Associate When You
Upgrade Access Point Firmware
Upgrade Access Point Firmware
Document ID: 6136
Contents
Introduction
Prerequisites
Requirements
Components Used
Conventions
Problem 1
Solution 1
Problem 2
Solution 2
Related Information
Prerequisites
Requirements
Components Used
Conventions
Problem 1
Solution 1
Problem 2
Solution 2
Related Information
Introduction
This document describes why the client cannot associate to an Access Point (AP) under these conditions:
Runs Lightweight Extensible Authentication Protocol (LEAP)/asynchronous communications server
(ACS).
(ACS).
•
The firmware on the AP is upgraded to 11.06 or later.
•
The firmware on the client is upgraded to version 4.25.
•
Prerequisites
Requirements
There are no specific requirements for this document.
Components Used
The information in this document is based on these software and hardware versions:
AP340 firmware version 11.06, and PC340 firmware version 4.25.5.
•
AP AIR−AP342E2R and Client Adapter AIR−PCM342.
•
The information in this document was created from the devices in a specific lab environment. All of the
devices used in this document started with a cleared (default) configuration. If your network is live, make sure
that you understand the potential impact of any command.
devices used in this document started with a cleared (default) configuration. If your network is live, make sure
that you understand the potential impact of any command.
Conventions
Refer to Cisco Technical Tips Conventions for more information on document conventions.