Cisco Cisco Aironet 350 Wireless Bridge 정보 가이드
Cisco Aironet Access Point FAQ
Document ID: 8103
Refer to the Cisco Wireless Software Center (
registered customers only
) in
order to get Cisco Aironet drivers, firmware and utility software.
Contents
Introduction
Design FAQ
Troubleshoot FAQ
Related Information
Design FAQ
Troubleshoot FAQ
Related Information
Introduction
This document provides answers to the most frequently asked questions (FAQ) about Cisco Aironet Access
Points (APs).
Points (APs).
Refer to Cisco Technical Tips Conventions for more information on document conventions.
Design FAQ
Q. What is the default user name and password for Cisco IOS®
Software−based APs?
Software−based APs?
A. Cisco IOS Software−based APs have a default configuration that includes a user name and
password combination, both of which are Cisco (case sensitive). After you reset to factory
defaults, be ready to give Cisco as both the username and password when either the GUI or
the command−line interface (CLI) prompts you.
password combination, both of which are Cisco (case sensitive). After you reset to factory
defaults, be ready to give Cisco as both the username and password when either the GUI or
the command−line interface (CLI) prompts you.
Q. What cable should I use for a console connection?
A. Use a straight−through cable with nine−pin male to nine−pin female connectors in order to
connect the COM1 or COM2 port on your computer to the RS−232 port on the AP. Use a
terminal emulation program on your computer, such as:
connect the COM1 or COM2 port on your computer to the RS−232 port on the AP. Use a
terminal emulation program on your computer, such as:
Microsoft Windows HyperTerminal
♦
Symantec ProComm
♦
Minicom
♦
Use these port settings:
Speed:
9600 bits per second (bps)
Data bits:
8
Stop bits:
1
Parity:
None
Flow Control:
Xon/Xoff