Cisco Cisco Aironet 1400 Wireless Bridge 릴리즈 노트

The PoE power status can also be found in the PoE Status section on the network interfaces>network 
status page on the access point GUI. The status statements can include any of the following:

Normal (full power)

Low (radio disabled)

Lower than 15.4 W

Lower than 16.8 W

If you use the AC power adapter to provide power to the access point, you do not need to adjust the access 
point configuration.

If you use a switch to provide PoE to the access point and the switch supports the IEEE 802.3af power 
negotiation standard, select Power Negotiation on the System Software: System Configuration page. 

If you use a switch to provide Power over Ethernet (PoE) to the access point and the switch does not 
support the IEEE 802.3af power negotiation standard, select Pre-Standard Compatibility on the 
System Software: System Configuration page. 

If you use a power injector to provide power to the access point, select Power Injector on the System 
Software: System Configuration page, and enter the MAC address of the switch port to which the access 
point is connected.