Cisco Cisco AP541N Wireless Access Point 관리 매뉴얼

Modifying Virtual Access Point Settings

Cisco AP541N Dual-band Single-radio Access Point Quick Start Guide

69

 

Select the cipher suite you want to use:

•

TKIP

•

CCMP (AES)

•

TKIP and CCMP (AES)

By default both TKIP and CCMP are selected. When both 
TKIP and CCMP are selected, client stations configured to 
use WPA with RADIUS must have one of the following:

•

A valid TKIP RADIUS IP address and RADIUS Key

•

A valid CCMP (AES) IP address and RADIUS Key

Displays which RADIUS server is in use. You can manually 
change from this server to a different server by selecting the 
desired server in the dropdown box. 

The Active Server is not stored across reboots. The 

first configured RADIUS server is selected when the device 
is rebooted or reset.

By default each VAP uses the global RADIUS settings that 
you define for the access point at the top of the VAP page. 
However, you can configure each VAP to use a different set of 
RADIUS servers. 

To use the global RADIUS server settings, make sure the 
check box is selected. 

To use a separate RADIUS server for the VAP, clear the check 
box and enter the RADIUS server IP address and key in the 
fields.

Enter the address for the primary RADIUS server for this VAP. 

Enter up to three IPv4 addresses to use as the backup 
RADIUS servers for this VAP.

If authentication fails with the primary server, each 
configured backup server is tried in sequence.