Cisco Cisco AP541N Wireless Access Point 관리 매뉴얼

Rogue AP Detection

Cisco AP 541N Dual-band Single-radio Access Point Quick Start Guide

36

 

If an access point is in the Detected Rogue AP List, you can 
click Grant to move the access point from the Detected 
Rogue AP List to the Known AP List.

If an access point is in the Known AP List, click the Delete 
button to move the access point from the Known AP List to 
the Detected Rogue AP List. 

The Detected Rouge AP List and Known AP List 

provide information only; the Cisco AP 541N does not have 
any control over the access points on the list and cannot 
apply any security policies to access points detected 
through the RF scan.

Shows the MAC address of the detected access point.

Shows the Beacon interval of another access point.

Beacon frames are transmitted by an access point at regular 
intervals to announce their existence on the wireless 
network. The default behavior is to send a beacon frame 
once every 100 milliseconds (or 10 per second).

The Beacon Interval for your access point is set on the 
Wireless > Advanced Settings page. (See 

Indicates the type of device:

•

AP indicates the detected device is an access point 
that supports the IEEE 802.11 Wireless Networking 
Framework in Infrastructure Mode.

•

Ad hoc designation indicates a neighboring station 
running in ad hoc mode. Stations set to ad hoc mode 
communicate with each other directly, without the use 
of a traditional access point. Ad-hoc mode is an IEEE 
802.11 Wireless Networking Framework also referred 
to as peer-to-peer mode or an Independent Basic 
Service Set (IBSS).