Cisco Cisco WAP4410N Wireless-N Access Point - PoE Advanced Security 릴리즈 노트

Release Notes for WAP4410N Access Point Firmware Version 2.0.6.1

3

•

CSCts76476—The access point may periodically experience loss of 
connectivity when configured in bridge mode. Workaround: Unplug the 
power adaptor or PoE cable, and then plug it back in.

•

CSCtz05399—The WAP4410N displays only one IPv6 address when set 
to IPv6 autoconfiguration. For example, if the router is advertising multiple 
prefixes, a local (fec0::) and a global site (2001::), the access point only 
acquires one of the two addresses.

•

CSCtz59478—When enabling or disabling the VLAN or QoS features, your 
Internet connection will be lost. Workaround: After configuring the VLAN or 
QoS features, unplug the power adaptor or PoE cable, and then plug it back 
in. 

The firmware was updated and the following issues were fixed in firmware version 
2.0.5.3.

•

CSCtz79093—Wireless isolation functionality between (and within) SSIDs 
is now fixed.

•

CSCtz79020—Fixed inability to assign static IPv6 address using the web-
based configuration utility.

•

CSCtz79064—Added a separate IP-type setting option for IPv6 in the 
web-based configuration utility.

•

CSCty33244—WPS can now be disabled using SSH.

•

CSCty33308—WPS is disabled by default. However, a factory reset must 
be performed first — either press the Reset button for approximately 10 
seconds, or use the web-based utility. Alternatively, you may choose to 
disable WPS using SSH. 

These known issues were identified in firmware version 2.0.5.3.

•

CSCtz79103—When selecting a 128-bit WEP key and providing a 
passphrase, one 128-bit key is generated. However, the default transmit 
key radio buttons allow you to pick from keys 1 through 4. The radio buttons 
for keys 2, 3, and 4 should be disabled.