Cisco Cisco Packet Data Gateway (PDG)
bind s1-mme
Binds the pre configured HeNB-GW Access Service to the IP address of the S1-MME interface.
Product
HeNB-GW
Privilege
Security Administrator, Administrator
Command Modes
Exec > Global Configuration > Context Configuration > HeNBGW-Access Service Configuration
configure > context context_name > henbgw-access-service service_name
Entering the above command sequence results in the following prompt:
[
context_name
]
host_name
(config-henbgw-access-service)#
Syntax Description
bind s1-mme { ipv4-address | ipv6-address } ip_addr max-subscribers max_sub
no bind s1-mme
no bind s1-mme
no
Removes the binding of S1-MME interface from this HeNB-GW Access service configuration.
ip_addr
Identifies the IP address of the S1-MME interface to associate with this HeNB-GW Access service.
addr_val must be entered in the IPv4 ( dotted decimal notation) or IPv6 (: / :: notation) .
max-subscribers max_sub
Configures the maximum number of subscribers HENBGW ACCESS service can support.
max_sub is an integer ranging from 0 through 4000000.
Usage Guidelines
Use this command to bind the pre configured IPv4 address of the S1-MME interface to the HeNB-GW Access
Service.
Service.
Examples
Following command binds the S1-MME interface having 192.68.111.61IP address with specific HeNB-GW
Access service.
bind s1-mme ipv4-address 192.68.111.61 max-subscribers
Access service.
bind s1-mme ipv4-address 192.68.111.61 max-subscribers
20
Command Line Interface Reference, Modes G - H, StarOS Release 19
1323
HeNB-GW Access Service Configuration Mode Commands
bind s1-mme