Cisco Cisco Packet Data Gateway (PDG)
threshold cpu-utilization
Configures alarm or alert thresholds for CPU utilization within the system.
Product
All
Privilege
Security Administrator, Administrator
Command Modes
Exec > Global Configuration
configure
Entering the above command sequence results in the following prompt:
[local]
host_name
(config)#
Syntax Description
threshold cpu-utilization high_thresh [ clear low_thresh ]
high_thresh
Default: 85
Specifies the high threshold CPU utilization percentage that must be met or exceeded within the polling
interval to generate an alert or alarm.
interval to generate an alert or alarm.
high_thresh is an integer from 0 through 100.
clear low_thresh
Default: 85
Specifies the low threshold CPU utilization percentage that maintains a previously generated alarm condition.
If the utilization percentage falls below the low threshold within the polling interval, a clear alarm will be
generated.
If the utilization percentage falls below the low threshold within the polling interval, a clear alarm will be
generated.
low_thresh is an integer from 0 through 100.
This value is ignored for the Alert model. In addition, if this value is not configured for the Alarm model,
the system assumes it is identical to the high threshold.
the system assumes it is identical to the high threshold.
Important
Usage Guidelines
CPU utilization thresholds generate alerts or alarms based on the utilization percentage of each packet processing
card CPU during the specified polling interval. Although, a single threshold is configured for all CPUs, separate
alerts or alarms can be generated for each CPU.
card CPU during the specified polling interval. Although, a single threshold is configured for all CPUs, separate
alerts or alarms can be generated for each CPU.
Command Line Interface Reference, Modes G - H, StarOS Release 19
495
Global Configuration Mode Commands (T-threshold phspc)
threshold cpu-utilization