Cisco Cisco ASR 5000
Local Policy Actiondef Configuration Mode Commands
▀ action
▄ Command Line Interface Reference, StarOS Release 18
7018
action
This command configures the action priority for an actiondef.
Product
P-GW
SAEGW
Privilege
Security Administrator, Administrator
Mode
Exec > Global Configuration > Local Policy Service Configuration > Local Policy Actiondef Configuration
configure > local-policy-service service_name > actiondef actiondef_name
Entering the above command sequence results in the following prompt:
[context_name]host_name(config-local-policy-actiondef)#
Syntax
action priority priority action_name arguments
no action priority priority
priority priority
Specifies a priority for the specified action.
priority
must be a unique integer from 1 to 2048.
action_name arguments
The following actions are supported.
arguments
specify a set of parameters to be used when invoking the
action.
activate-ambr uplink bandwidth downlink bandwidth
Sets the aggregated maximum bit rate (AMBR) for the APN.
Configures uplink and downlink bandwidth.
bandwidth
must be an integer from 1 to 1000000000.
activate-flow-detection { initiation | termination } ruledef ruledef_name
Detects a flow and takes action.
initiation ruledef
: Checks for flow initiation and adds a rule definition.
termination ruledef
: Checks for flow termination and adds a rule definition.
ruledef_name
must be an existing ruledef.
activate-policy-group
This keyword is not supported in this release.
activate-rule name rule_name
Activates a rule within ECS rulebase for a subscriber.
rule_name
must be an existing rule within this local QoS policy service expressed as an
alphanumeric string of 1 through 63 characters.