Cisco Cisco ASR 5000
Local Policy Ruledef Configuration Mode Commands
▀ condition
▄ Command Line Interface Reference, StarOS Release 18
7032
condition
This command is used to configure the conditions which trigger the ruledef event.
Product
P-GW
SAEGW
Privilege
Security Administrator, Administrator
Mode
Exec > Global Configuration > Local Policy Service Configuration > Local Policy Ruledef Configuration
configure > local-policy-service service_name > ruledef ruledef_name
Entering the above command sequence results in the following prompt:
[context_name]host_name(config-local-policy-ruledef)#
Syntax
condition priority priority { variable { eq | ge | gt | le | lt | match | ne | nomatch }
regex | string_value | int_value | set }
regex | string_value | int_value | set }
no condition priority priority
priority priority
Specifies a priority for the specified condition.
priority
must be unique and an integer from 1 to 2048.
variable
The following variables are supported:
apn
The APN associated with the current session expressed as an alphanumeric string of 1 through 63
characters.
characters.
arp
The APN associated with the current session expressed as an integer from 1 through 15.
bandwidth
Total bandwidth associated with the QCI and ARP value associated with the request, expresed as an
integer from 0 through 1000000000.
integer from 0 through 1000000000.
bsid
Base Station Identifier associated with the subscriber as expressed as an alphanumeric string of 1
through 63 characters.
through 63 characters.
cause-code
Failure Cause Code associated with the subscriber as expressed as an alphanumeric string of 1
through 63 characters.
through 63 characters.
cgi