Cisco Cisco Packet Data Gateway (PDG)
IPv6 ACL Configuration Mode Commands
redirect css service (for uplink, by source IP address masking) ▀
Command Line Interface Reference, StarOS Release 18 ▄
6801
source_address
The IP address(es) form which the packet originated.
This option is used to filter all packets from a specific IP address or a group of IP addresses.
When specifying a group of addresses, the initial address is configured using this option. The range can then
be configured using the
This option is used to filter all packets from a specific IP address or a group of IP addresses.
When specifying a group of addresses, the initial address is configured using this option. The range can then
be configured using the
source_wildcard
parameter.
source_wildcard
This option is used in conjunction with the
source_address
option to specify a group of addresses for
which packets are to be filtered.
The mask must be entered as a complement:
The mask must be entered as a complement:
Zero-bits in this parameter mean that the corresponding bits configured for the
source_address
parameter must be identical.
One-bits in this parameter mean that the corresponding bits configured for the
source_address
parameter must be ignored.
Usage
Define a rule definition when any packet from the IP addresses which fall into the group of addresses
matching the IP address masking. This allows the reduction of filtering rule definitions as it does not require a
rule definition for each source and destination pair.
matching the IP address masking. This allows the reduction of filtering rule definitions as it does not require a
rule definition for each source and destination pair.
Example
The following command defines a rule definition to redirect packets to a charging service named
chgsvc1
:
redirect css service chgsvc1 uplink 1:1:1:1:1:1:1:1