Cisco Cisco ASR 5700
Global Configuration Mode Commands (T-threshold phspc)
threshold per-service-asngw-sessions ▀
Command Line Interface Reference, StarOS Release 17 ▄
5659
threshold per-service-asngw-sessions
Configures alarm or alert thresholds for the number of sessions per ASN-GW service in the system.
Product
ASN-GW
Privilege
Security Administrator, Administrator
Mode
Exec > Global Configuration
configure
Entering the above command sequence results in the following prompt:
[local]host_name(config)#
Syntax
threshold per-service-asngw-sessions high_thresh [ clear low_thresh ]
high_thresh
Default: 0
Specifies the high threshold number of PDP contexts for any one ASN-GW service that must be met or
exceeded within the polling interval to generate an alert or alarm.
Specifies the high threshold number of PDP contexts for any one ASN-GW service that must be met or
exceeded within the polling interval to generate an alert or alarm.
high_thresh
is an integer from 0 through 2500000. A value of 0 disables the threshold.
clear
low_thresh
Default: 0
Specifies the low threshold number of PDP contexts for any one ASN-GW service that maintains a
previously generated alarm condition. If the number of sessions falls beneath the low threshold within the
polling interval, a clear alarm will be generated.
Specifies the low threshold number of PDP contexts for any one ASN-GW service that maintains a
previously generated alarm condition. If the number of sessions falls beneath the low threshold within the
polling interval, a clear alarm will be generated.
low_thresh
is an integer from 0 through 2500000. A value of 0 disables the threshold.
Important:
This value is ignored for the Alert model. In addition, if this value is not configured for the Alarm
model, the system assumes it is identical to the high threshold.
Usage
Monitor and set alarms or alerts when the number of PDP contexts for any ASN-GW service in the system is
equal to or greater than the set limit.
Alerts or alarms are triggered for PDP contexts based on the following rules:
equal to or greater than the set limit.
Alerts or alarms are triggered for PDP contexts based on the following rules:
Enter condition: Actual number of PDP contexts for any ASN-GW service is greater than or equal to
the high threshold
Clear condition: Actual number of PDP contexts is less than the low threshold
If a trigger condition occurs within the polling interval, the alert or alarm will not be generated until the end
of the polling interval.
Refer to the
of the polling interval.
Refer to the
threshold poll
command to configure the polling interval and the
threshold monitoring
command to enable thresholding for this value.