Cisco Cisco Tunnel Terminating Gateway (TTG)
PCC-Sp-Endpoint Configuration Mode Commands
▀ spr subscriber identifier
▄ Command Line Interface Reference, StarOS Release 17
7748
spr subscriber identifier
This command sets the PCC-Sp-Endpoint instance to indicate how a subscriber is uniquely identified in SPR database
while requesting subscriber data from SSC.
while requesting subscriber data from SSC.
Product
IPCF
Privilege
Security Administrator, Administrator
Mode
Exec > Global Configuration > Context Configuration > PCC Sp Endpoint Configuration
configure > context context_name > pcc-sp-endpoint endpoint_name
Entering the above command sequence results in the following prompt:
[context_name]host_name(config-spendpoint)#
Syntax
spr subscriber identifier {imsi | msisdn | nai}
default spr subscriber identifier
default
Sets the PCC-Sp-Endpoint instance to use subscriber IMSI to identify subscriber uniquely in SPR database
while requesting subscriber data from SSC.
while requesting subscriber data from SSC.
imsi
Default: Enabled
Sets the PCC-Sp-Endpoint instance to use subscriber IMSI to identify subscriber uniquely in SPR database
while requesting subscriber data from SSC.
Sets the PCC-Sp-Endpoint instance to use subscriber IMSI to identify subscriber uniquely in SPR database
while requesting subscriber data from SSC.
msisdn
Default: Disabled
Sets the PCC-Sp-Endpoint instance to use subscriber MSISDN to identify subscriber uniquely in SPR
database while requesting subscriber data from SSC.
Sets the PCC-Sp-Endpoint instance to use subscriber MSISDN to identify subscriber uniquely in SPR
database while requesting subscriber data from SSC.
nai
Default: Disabled
Sets the PCC-Sp-Endpoint instance to use Network Address Identifier as token to identify subscriber
uniquely in SPR database while requesting subscriber data from SSC.
This token facilitates CDMA users for Policy Control and Charging functions.
Sets the PCC-Sp-Endpoint instance to use Network Address Identifier as token to identify subscriber
uniquely in SPR database while requesting subscriber data from SSC.
This token facilitates CDMA users for Policy Control and Charging functions.
Usage
Use command to set the PCC-Sp-Endpoint instance to indicate how a subscriber is uniquely identified in SPR
database on SSC while requesting subscriber data. By default it uses Subscriber IMSI for identification in
SPR database.
database on SSC while requesting subscriber data. By default it uses Subscriber IMSI for identification in
SPR database.