Cisco Cisco Packet Data Gateway (PDG)
Exec Mode show Commands (M-P)
▀ show mpls cross-connect
▄ Command Line Interface Reference, StarOS Release 16
4660
show mpls cross-connect
Displays Multiprotocol Label Switching (MPLS) cross-connect information.
Product
GGSN
Privilege
Security Administrator, Administrator
Mode
Exec
The following prompt is displayed in the Exec mode:
[local]host_name#
Syntax
show mpls cross-connect [ | { grep grep_options | more } ]
| { grep grep_options | more }
Pipes (sends) the output of the command to the command specified. You must specify a command to which
the output will be sent.
For details on the usage of the
the output will be sent.
For details on the usage of the
grep
and
more
commands, refer to the Regulating a Command’s Output
section in the Command Line Interface Overview chapter.
Usage
This command displays MPLS cross-connect information. MPLS tunnel cross-connects between interfaces
and Label-Switched Paths (LSPs) connect two distant interface circuits of the same type by creating MPLS
tunnels that use LSPs as the conduit.
and Label-Switched Paths (LSPs) connect two distant interface circuits of the same type by creating MPLS
tunnels that use LSPs as the conduit.
Example
The following command displays MPLS cross-connect information:
show mpls cross-connect
Important:
Output descriptions for these commands are available in the Statistics and Counters Reference.