Cisco Cisco Tunnel Terminating Gateway (TTG)
Call Control Profile Configuration Mode
subscriber-control-inactivity ▀
Command Line Interface Reference, StarOS Release 16 ▄
2031
subscriber-control-inactivity
Configures \the subscriber-control inactivity timer. The system detects inactivity when no PDP context is activated and
starts the timer.
starts the timer.
Product
SGSN
Privilege
Security Administrator, Administrator
Mode
Exec > Global Configuration > Call Control Profile Configuration
configure > call-control-profile profile_name
Entering the above command sequence results in the following prompt:
[local]host_name(config-call-control-profile-profile_name)#
Syntax
subscriber-control-inactivity timeout minutes time detach { immediate | next-connection |
reattach-time-period }
reattach-time-period }
{ no | default } subscriber-control-inactivity
no
Deletes the timer configuration.
default
Resets the timer configuration to the default value of 7 days (10080 minutes).
timeout minutes time[ detach ]
Sets the number of minutes the SGSN monitors the connection after inactivity has been detected. When the
timer expires, the subscribe will be detached.
timer expires, the subscribe will be detached.
time
: Enter an integer from 1 to 20160 (two weeks).
detach [ immediate | next-connection | reattach-time-period ]
Instructs the SGSN to detach and can be configured to specify when the detach will occur after inactivity is
detected. To fine-tune the detach instruction, include one of the following with the command:
detected. To fine-tune the detach instruction, include one of the following with the command:
immediate
- Instructs the SGSN to detach immediately after inactivity is detected. May combine with
reattach-time-period
.
next-connection
- instructs the SGSN to detach after the next Iu connection after inactivity is
detected.
Important:
Supported for 3G SGSNs only.