Cisco Cisco ASR 5000

The RADIUS attributes listed in the following table are used to configure Traffic Policing for CDMA
subscribers (PDSN, HA) configured on remote RADIUS servers. More information on these attributes can
be found in the AAA Interface Administration and Reference.

Enable/disable traffic policing in the downlink direction.

SN-QoS-Tp-Dnlk

(or SN1-QoS-Tp-Dnlk)

Specifies the downlink committed-data-rate in bps.

SN-Tp-Dnlk-Committed-Data-Rate

(or SN1-Tp-Dnlk-Committed-Data-Rate)

Specifies the downlink peak-data-rate in bps.

SN-Tp-Dnlk-Peak-Data-Rate

(or SN1-Tp-Dnlk-Committed-Data-Rate)

Specifies the downlink-burst-size in bytes.

NOTE: It is recommended that this parameter be
configured to at least the greater of the following two
values: 1) 3 times greater than packet MTU for the
subscriber connection, OR 2) 3 seconds worth of token
accumulation within the "bucket" for the configured
peak-data-rate.

SN-Tp-Dnlk-Burst-Size

(or SN1-Tp-Dnlk-Burst-Size)

Specifies the downlink exceed action to perform.

SN-Tp-Dnlk-Exceed-Action

(or SN1-Tp-Dnlk-Exceed-Action)

Specifies the downlink violate action to perform.

SN-Tp-Dnlk-Violate-Action

(or SN1-Tp-Dnlk-Violate-Action)

Enable/disable traffic policing in the downlink direction.

SN-QoS-Tp-Uplk

(or SN1-QoS-Tp-Uplk)

Specifies the uplink committed-data-rate in bps.

SN-Tp-Uplk-Committed-Data-Rate

(or SN1-Tp-Uplk-Committed-Data-Rate)

Specifies the uplink peak-data-rate in bps.

SN-Tp-Uplk-Peak-Data-Rate

(or SN1-Tp-Uplk-Committed-Data-Rate)