Cisco Cisco Packet Data Interworking Function (PDIF)
Configuring the SaMOG Gateway
Configuring the System to Perform as a SaMOG Gateway ▀
SaMOG Administration Guide, StarOS Release 18 ▄
117
end
Flow-based Local Breakout
config
apn-profile apn_profile_name
local-offload flow
ip context-name vpn_context_name
ip access-group access_list_name [ in | out ]
active-charging rulebase rulebase_name
exit
context context_name
ip access-list access_list_name
redirect css service acs_service_name any
exit
exit
After applying the above initial configuration for Flow-based LBO, you can configure either a flow-based LBO
whitelist or a blacklist.
whitelist or a blacklist.
Flow-based LBO with External NAT
SaMOG can also perform flow-based LBO with external NAT devices based on nex-hop. Configure flow-based LBO
with an external NAT by applying the example configuration below:
with an external NAT by applying the example configuration below:
config
active-charging service acs_service_name
rulebase rulebase_name
action priority action_priority_1 ruledef ruledef_name_1 charging-action
charging_action_name
charging_action_name
action priority action_priority_2 ruledef ruledef_name_2 charging-action
charging_action_name
charging_action_name
exit
ruledef ruledef_name_1
ip dst-address = ipv6_address[/mask ]
exit