Cisco Cisco Packet Data Gateway (PDG) 전단
Context Configuration Mode Commands N-R
network-requested-pdp-context activate ▀
Cisco ASR 5x00 Command Line Interface Reference ▄
2477
is specified, the system uses the configured IMSI and APN to determine the appropriate SGSN from the
Home Location Register (HLR). The system communicates with the HLR through the interworking node
configured using the network-requested-pdp-context gsn-map command.
Once the session is established, the destination context specified by this command is used in place of the one
either configured within the specified APN template or returned by a RADIUS server during authentication.
This command can be issued multiple times supporting network initiated PDP contexts for up to 1,000
configured addresses per system context.
Home Location Register (HLR). The system communicates with the HLR through the interworking node
configured using the network-requested-pdp-context gsn-map command.
Once the session is established, the destination context specified by this command is used in place of the one
either configured within the specified APN template or returned by a RADIUS server during authentication.
This command can be issued multiple times supporting network initiated PDP contexts for up to 1,000
configured addresses per system context.
Example
The following command enables support for network initiated PDP contexts for an MS with a static IP
address of
address of
20.13.5.40
from a pool configured in the destination context pdn1 with an IMSI of
3319784450
that uses an APN template called
isp1
:
network-requested-pdp-context activate address 20.13.5.40 dst-context
pdn1 imsi 3319784450 apn isp1
pdn1 imsi 3319784450 apn isp1