Cisco Cisco Tunnel Terminating Gateway (TTG) 전단
Context Configuration Mode Commands I-M
▀ ikev1 disable-initial-contact
▄ Cisco ASR 5x00 Command Line Interface Reference
2360
ikev1 disable-initial-contact
Disables the sending of the INITIAL-CONTACT message in the IKEv1 protocol after the node creates a new Phase1
SA, caused either by Dead Peer Detection or by a rekey.
SA, caused either by Dead Peer Detection or by a rekey.
Product
GGSN
Privilege
Security Administrator, Administrator
Mode
Exec > Global Configuration > Context Configuration
configure > context context_name
Entering the above command sequence results in the following prompt:
[context_name]host_name(config-ctx)#
Syntax
[ no ] ikev1 disable-initial-contact
no
Disables this command, which re-enables the sending of the INITIAL-CONTACT message.
Usage
Use this command to disable the sending of the INITIAL-CONTACT message in the IKE v1protocol.
Example
The following command disables the sending of the INITIAL-CONTACT message:
ikev1 disable-initial-contact