Cisco Cisco Packet Data Gateway (PDG)
show port
▀
▄ Statistics and Counters Reference, StarOS Release 16
4674
Field
Description
Link
The link status – Up or Down.
State
The operational mode of the card that the port belongs to. The card can be in one of the
following modes:
following modes:
Active: Indicates that the card is an active component that will be used to process
subscriber data sessions.
subscriber data sessions.
Standby: Indicates that the card is a redundant component. Redundant components
will become active through manual configuration or automatically should a failure
occur.
will become active through manual configuration or automatically should a failure
occur.
Offline: Indicates that the card is installed but is not ready to process subscriber data
sessions. This could be because it is not completely installed (for example. the card
interlock switch is not locked). Refer to the Installation Guide for additional
information.
sessions. This could be because it is not completely installed (for example. the card
interlock switch is not locked). Refer to the Installation Guide for additional
information.
Pair
The redundant port for that port. If a redundant port is not available, None will be displayed.
Extra information is shown in the “Redundant” column when the port is in a link aggregation
group. It now shows “LAG” and the redundant card/port detail.
Extra information is shown in the “Redundant” column when the port is in a link aggregation
group. It now shows “LAG” and the redundant card/port detail.
Redundant
An aggregated port can be selected and collecting data, and either distributing data or not
distributing data.
If the port is distributing data, a “+” sign appears in the port detail next to the “LAG” entry. If
the port is not distributing data, then a “-” sign appears instead.
distributing data.
If the port is distributing data, a “+” sign appears in the port detail next to the “LAG” entry. If
the port is not distributing data, then a “-” sign appears instead.
Untagged:
Indicates the administrative, operational, link and active/standby states of an untagged
(non-VLAN) port.
(non-VLAN) port.
Tagged:
VLAN
<vlan_id>
VLAN
<vlan_id>
Indicates the administrative, operational, link and active/standby states of a VLAN port.
show port transceiver (ASR 5500)
Table 472.
show port transceiver
Command Output Descriptions (ASR 5500)
Field
Description
Port <slot/port>
Specifies the chassis slot and port number for the port.
SFP Transceiver info
Identifies the type of transceiver installed in the port.
SFP Vendor info
Vendor Name: Identifies the vendor’s name
Vendor IEEE ID: Displays the module vendor’s IEEE ID.
Vendor IEEE ID: Displays the module vendor’s IEEE ID.