Cisco Cisco Packet Data Gateway (PDG) 릴리스 노트
System Changes in Release 15.0
System and Platform Enhancements for September 30, 2013 ▀
Cisco ASR 5x00 Release Change Reference ▄
613
ipsg | lns | mme | pdif | proxy-cscf | rfc3261-proxy | serving-cscf } next-call | type
bcmcs { next-call | next-service-request } | username user_name | Next-Call By APN ]
bcmcs { next-call | next-service-request } | username user_name | Next-Call By APN ]
require demux card management-card
This command transitions the standby MIO/UMIO card in an ASR 5500 to host all the demux tasks on StarOS. It is
enabled via the require demux card management-card command.
enabled via the require demux card management-card command.
configure
require demux card [ management-card | processing-card ]
end
Note:
Demux card functionality is disabled by default on the ASR 5500 and ASR 5000. The require demux card
management-card command is only supported for GGSN, P-GW, S-GW, HA and SAEGW running on an
ASR 5500; it is not supported on the ASR 5000 for any product. This feature is explicitly not supported for Ex-
GW, MME and SGSN because these products use a higher proportion of MIO/UMIO CPU resources.
ASR 5500; it is not supported on the ASR 5000 for any product. This feature is explicitly not supported for Ex-
GW, MME and SGSN because these products use a higher proportion of MIO/UMIO CPU resources.
To support this feature session recovery must also be enabled via the Global Configuration mode require
session recovery command on the ASR 5500.
Running require demux card processing-card dedicates a DPC/UDPC to run demux functions in the ASR
5500.
Important:
After enabling demux card and session recovery, you must save the configuration and reboot the
ASR 5500 to enable demux card functions on the standby MIO/UMIO card.
shutdown
The shutdown command for Ethernet ports has been modified to power down ports on FELC, GELC and QGLC line
cards (ASR 5000). This command already powers down ports on MIO/UMIO cards (ASR 5500).
cards (ASR 5000). This command already powers down ports on MIO/UMIO cards (ASR 5500).
configure
port ethernet slot_number/port_number
shutdown
end
Deprecated System Commands
This section identifies system commands that are no longer supported in release 15.0.
hidden password
This debug level command has been deprecated in this release. Its functionality has been replaced by the newly added
tech-support test-commands command.
tech-support test-commands command.