Cisco Cisco WAP200 Wireless-G Access Point - PoE Rangebooster 관리 매뉴얼
8
Chapter 3: Getting to Know the Wireless-G Access Point
The Ports
The Ports
Wireless-G Access Point with Power Over Ethernet and Rangebooster
The Ports
The Access Point’s port are located on the back of the device.
Reset Button
There are two ways to reset the Access Point to the factory default configuration. Either press
the Reset button, for approximately ten seconds, or restore the defaults using the Access
Point's web-based utility.
the Reset button, for approximately ten seconds, or restore the defaults using the Access
Point's web-based utility.
Ethernet
The Ethernet network port connects to Ethernet network devices, such as a switch or router
that may or may not support Power over Ethernet (PoE).
that may or may not support Power over Ethernet (PoE).
Power
The Power port connects to the supplied power adapter.
port: the connection point on a computer or
networking device used for plugging in
cables or adapters
networking device used for plugging in
cables or adapters
Figure 3-2: Back View
IMPORTANT: Resetting the Access Point will
erase all of your settings (including wireless
security, IP address, and SSID) and replace
them with the factory defaults. Do not reset
the Access Point if you want to retain these
settings.
erase all of your settings (including wireless
security, IP address, and SSID) and replace
them with the factory defaults. Do not reset
the Access Point if you want to retain these
settings.