Cisco Cisco WAP2000 Wireless-G Access Point - PoE 관리 매뉴얼

Configuring the Access Point’s Modes of Operation

Cisco WAP2000 Wireless-G Access Point with Power Over Ethernet Administration Guide

50

 

To configure the access point mode settings of the access point, follow these 
steps:

Click AP Mode > AP Mode.

The MAC address of the access point is displayed below the window’s title.

To configure the access point for operation as an access point, click Access Point 
(default), if it is not already selected. This connects your wireless computers to a 
wired network. In most cases, no change is necessary. Provide the following 
information:

•

Allow wireless signal to be repeated by a repeater—Check this option to 
use another wireless device to repeat the signal of this access point.

•

MAC1 to MAC3—Enter the MAC addresses of up to three wireless devices 
that should act as the repeaters. You can use up to 3 repeaters.

To configure the access point for operation as a wireless repeater, click Wireless 
Repeater and fill in the following information:

•

Remote Access Point’s MAC Address—Click Site Survey to select the 
access point that has its signal repeated by this access point or enter the 
MAC address of the access points manually in the MAC field.

To configure the access point for operation as a wireless bridge, click Wireless 
Bridge and fill in the following information:

•

Remote Wireless Bridge’s MAC Addresses—Enter the MAC addresses of 
the access points that bridge to this access point in the fields below.

Click Save.