Cisco Cisco WAP371 Wireless-AC N Access Point with Single Point Setup 설치 가이드

Follow the Setup Wizard instructions to finish the WAP device 
installation. We strongly recommend that you use the Setup 
Wizard for the first installation.The Setup Wizard turns on the Wi-Fi 
radio, which allows you to connect wirelessly. For more advanced 
configurations, see the Administration Guide. A link to the 
Administration Guide is found in 

.

Congratulations, you can now start using your wireless access point.

In case of an error while installing, try the following troubleshooting 
procedures described in this section:

If you cannot display the configuration utility, you can test the ability of the 
computer to communicate with the device by using ping. To use ping on a 
computer running Windows:

Verify that the Cisco WAP371 is powered on and the lights indicate 
the appropriate links.

Locate the device’s IP address. While there are different ways to 
locate your device’s IP address, this procedure uses Cisco FindIT.

a.

If you have previously downloaded Cisco FindIT, open Internet 
Explorer and launch Cisco FindIT. For more information on 
downloading Cisco FindIT, see 

www.cisco.com/go/findit

.

b. In the Cisco FindIT display, place your mouse over the device’s 

name. The device IP address is displayed along with other 
device information.

Open a command window by choosing Start > Run and enter 
cmd.

At the command window prompt, enter ping and the device IP 
address. In this example, we pinged 192.0.2.10. 

If successful, you should get a reply similar to the following:

Pinging 192.0.2.10 with 32 bytes of data:
Reply from 192.0.2.10: bytes=32 time<1ms TTL=128