Cisco Cisco WAP371 Wireless-AC N Access Point with Single Point Setup 릴리즈 노트

2

Release Notes

Open Caveats

These are the open caveats for firmware version 1.0.0.10

Table 1

Open Caveats in Firmware Version 1.0.0.10

Ref Number

Description

CSCul73641 

Symptom:

WAP371 Wireless reason 3:STA is leaving IBSS or ESS issue.

Workaround:

This issue occurs when there is much interference in the environment. Set up the 

wireless network with a rational design. 

CSCul48943

Symptom:

GUI responds really slow after clicking Save. 

Workaround:

This issue occurs occasionally on specific PCs with different OS browsers. 

CSCun58608

Symptom:

Power  LED  flashes even after setting the  static  ipv4/ipv6  address. 

Workaround:

This issue occurs when the WAP does not receive the DHCP address. 

CSCuo18776

Symptom:

POE power warning. 

Workaround:

If you enable 80 MHz channel (@5G radio) and the channel carries a high amount 

of traffic, then the WAP device will need more power than what the IEEE 802.3af PoE standard 
provides (12.95 W). We highly recommend that when the 80 M channel is enabled, the WAP 
device should either be powered by a power adapter or an 802.3at Power Source Equipment 
(PSE). If the required power for the WAP device exceeds the maximum power delivered by the 
PSE, then the WAP device may reboot.