Cisco Cisco WAP351 Wireless-N Dual Radio Access Point with 5-Port Switch 설치 가이드

Follow the Setup Wizard instructions to finish the WAP device 
installation. The Setup Wizard turns on the Wi-Fi radio, which 
allows you to connect wirelessly. 

We strongly recommend that you use the Setup Wizard for the first 
installation. For more advanced configurations, see the 
Administration Guide. A link to the Administration Guide is found in 

.

Congratulations, you can now start using the Cisco WAP351.

In case of an error while installing, try the troubleshooting procedures 
described in this section. 

If you cannot display the 

web-basedConfiguration Utility, you can test the 

ability of the computer to communicate with the Cisco WAP351 by using 
ping. 

To use ping on a computer running Windows: 

Verify that the Cisco WAP351

is powered on and the lights if they 

do not indicate the appropriate links.

Locate the Cisco WAP351’s IP address. While there are different 
ways to locate the IP address, this procedure uses Cisco FindIT.

a.

If you have previously downloaded Cisco FindIT, open Internet 
Explorer and launch Cisco FindIT. For more information on 

downloading Cisco FindIT, see 

www.cisco.com/go/findit

.

b. In the Cisco FindIT display, place your mouse over the device’s 

name. The Cisco WAP351’s IP address is displayed along with 
other device information.

Open a command window by choosing Start > Run and enter 
cmd.

At the command window prompt, enter ping and the Cisco 
WAP351’s IP address. In this example, we pinged 192.0.2.10. 

If successful, you should get a reply similar to the following:

Pinging 192.0.2.10 with 32 bytes of data:
Reply from 192.0.2.10: bytes=32 time<1ms TTL=128