Cisco Cisco WAP321 Wireless-N Access Point with Single Point Setup 릴리즈 노트
6
Release Notes
Cisco WAP121 and WAP321 Wireless Access Points, Firmware Version
1.0.3.4
1.0.3.4
Version 1.0.3.4
March, 2013
These release notes describe the changes in the new firmware for the Cisco WAP121 and
WAP321 Wireless Access Points.
WAP321 Wireless Access Points.
New in This Release
Wireless security enhancement. After resetting the access point to factory defaults, it will use
WPA2-PSK security with a device-generated random key.
WPA2-PSK security with a device-generated random key.
Requirements
•
Your computer must meet the recommended hardware and software requirements.
•
A computer with Browser support for:
-
Internet Explorer v7.0 or later
-
Chrome v5.0 or later
-
Firefox v3.0 or later
-
Safari v3.0 or later
Limitations
CSCty78355—The Cisco WAP321 and WAP121 devices do not support multicast traffic over
Work Group Bridge mode. This is a design limitation of the Wireless Ethernet in Work Group
Bridge. Work Group Bridge translates and maps an IP address to a MAC address in the WET
table, which works only for Unicast IP addresses.
Work Group Bridge mode. This is a design limitation of the Wireless Ethernet in Work Group
Bridge. Work Group Bridge translates and maps an IP address to a MAC address in the WET
table, which works only for Unicast IP addresses.
Resolved Issues
CSCub46649—While operating WDS Bridging using a 2.4 GHz band with a 20/40 MHz
channel bandwidth, the WDS links may disconnect. The radio can change from 40 MHz to 20
MHz if any 20 MHz devices are detected in the area, resulting in a mismatch of channel
bandwidths throughout the WDS devices.
channel bandwidth, the WDS links may disconnect. The radio can change from 40 MHz to 20
MHz if any 20 MHz devices are detected in the area, resulting in a mismatch of channel
bandwidths throughout the WDS devices.