Cisco Cisco WAP200E Wireless-G Exterior Access Point - PoE 데이터 시트
Data Sheet
© 2009-2010 Cisco and/or its affiliates. All rights reserved. This document is Cisco Public Information.
Page 3 of 5
Table 1.
Specifications for the Cisco WAP200E Wireless-G Exterior Access Point: PoE
Specifications
Standards
IEEE 802.11g, IEEE 802.11b, IEEE 802.3, IEEE 802.3u, IEEE 802.3af (PoE), 802.1p (QoS priority), 802.1Q
(VLAN), 802.1X (security authentication), 802.11i ready (security WPA2), 802.11e ready (WMM and unsolicited
automatic power save delivery [U-APSD]), 802.11F (wireless roaming)
(VLAN), 802.1X (security authentication), 802.11i ready (security WPA2), 802.11e ready (WMM and unsolicited
automatic power save delivery [U-APSD]), 802.11F (wireless roaming)
Ports
1 Ethernet, 1 external antenna
Buttons
Reset
Cabling type
Unshielded twisted pair (UTP) Category 5
LEDs
Power, Ethernet, Wireless
Operating system
Linux
Setup/Configuration
Web user interface
Built-in web user interface for easy browser-based configuration (HTTP/HTTPS)
Static IP
Yes
Dynamic Host Configuration
Protocol (DHCP) client
Protocol (DHCP) client
Yes
Management
SNMP versions
1, 2, and 2c
Event logging
Yes
Web firmware upgrade
Yes
Diagnostics
Flash, RAM, LAN, WLAN
Operating Modes
Access point
Access point mode, point-to-point bridge mode, point-to-multipoint bridge mode, repeater mode
Wireless
Spec/modulation
802.11b/direct sequence spread spectrum (DSSS), 802.11g/orthogonal frequency division multiplexing (ODFM)
Data rates
802.11b: 1, 2, 5.5, 11 Mbps; 802.11g: 6, 9, 11, 12, 18, 24, 36, 48, 54 Mbps
Channels
11 North America, 13 Europe (ETSI and Japan) auto-channel selection
Number of internal antennas
2 at 6 dBi (directional)
Antenna connector type
Reverse polarity female N-type
Detachable antenna
Yes (sold separately)
RF power (Effective Isotropic
Radiated Power [EIRP])
Radiated Power [EIRP])
802.11g: typical 16.5 dBm, 802.11b: typical 17 dBm
Antenna gain
Internal antenna: 6 dBi
Adjustable power
Yes
Receiver sensitivity
802.11g: 54 Mbps at -65 dBm, 802.11b: 11 Mbps at -85 dBM
Security
WEP/WPA/WPA2
WEP, WPA-PSK, WPA2-PSK, WPA Enterprise, WPA2 Enterprise
Connection control
Wireless connection control: MAC based
SSID broadcast
SSID broadcast enable/disable
802.1X
IEEE 802.1X support
Wireless client isolation
Wireless client devices can be isolated from each other either within an SSID or between 2 SSIDs; both isolation
modes can be enabled at the same time.
modes can be enabled at the same time.
Web-based utility access
control
control
HTTP/HTTPS, wireless client web GUI access control
Wireless Security
WEP bits
64, 128
WPA bits and parameters
128 - Temporal Key Integrity Protocol (TKIP)/Advanced Encryption Standard (AES)
WPA2 bits and parameters
256 - AES
SSID broadcast on/off
Yes
Client isolation
Yes