Cisco Cisco WAP121 Wireless-N Access Point with Single Point Setup 설치 가이드

For specific details about the years, revisions and relevant amendments please refer to the applicable 
declaration of conformity available at

This section includes the EMC Class B warnings for the Cisco WAP121 Wireless Access Point.

Modifying the equipment without Cisco’s authorization may result in the equipment no longer 
complying with FCC requirements for Class B digital devices. In that event, your right to use the 
equipment may be limited by FCC regulations, and you may be required to correct any interference to 
radio or television communications at your own expense.

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant 
to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful 
interference in a residential installation. This equipment generates, uses and can radiate radio frequency 
energy and, if not installed and used in accordance with the instructions, may cause harmful interference 
to radio communications. However, there is no guarantee that interference will not occur in a particular 
installation. If this equipment does cause harmful interference to radio or television reception, which can 
be determined by turning the equipment off and on, the user is encouraged to try to correct the 
interference by one or more of the following measures:

Reorient or relocate the receiving antenna.

Increase the separation between the equipment and receiver.

Connect the equipment into an outlet on a circuit different from that to which the receiver is 
connected.

Consult the dealer or an experienced radio/TV technician for help.

Radio

47CFR FCC Part 15C 
Industry Canada RSS-210 
EN 300 328 

RF Exposure

FCC OET 65, Supplement C 
RSS-102 
EN 50385