Cisco Cisco WAP121 Wireless-N Access Point with Single Point Setup 릴리즈 노트
2
Release Notes
These release notes describe the changes in the new firmware for the Cisco WAP121 and
WAP321 Wireless Access Points.
WAP321 Wireless Access Points.
Requirements
•
Your computer must meet the recommended hardware and software requirements.
•
A computer with Browser support for:
-
Internet Explorer v7.0 or later
-
Chrome v5.0 or later
-
Firefox v3.0 or later
-
Safari v3.0 or later
Limitations
CSCty78355—The Cisco WAP321 and WAP121 devices do not support multicast traffic over
Work Group Bridge mode. This is a design limitation of the Wireless Ethernet in Work Group
Bridge. Work Group Bridge translates and maps an IP address to a MAC address in the WET
table, which works only for Unicast IP addresses.
Work Group Bridge mode. This is a design limitation of the Wireless Ethernet in Work Group
Bridge. Work Group Bridge translates and maps an IP address to a MAC address in the WET
table, which works only for Unicast IP addresses.
Resolved Issues
CSCuf27908—When using MAC authentication with a Radius server, the AP may hang then
reboot when the soft watchdog timer expires.
reboot when the soft watchdog timer expires.
CSCui03102—Apple clients performance issue.
CSCul99063—S5P4: Change order of captive portal configuration options.