Cisco Cisco WAP121 Wireless-N Access Point with Single Point Setup 릴리즈 노트
8
Release Notes
Cisco WAP121 and WAP321 Wireless Access Points, Firmware Version
1.0.2.3
1.0.2.3
Version 1.0.2.3
January, 2013
These release notes describe the changes in the new firmware for the Cisco WAP121 and
WAP321 Wireless Access Points.
WAP321 Wireless Access Points.
New in This Release
This release provides support for Single Point Setup, a simple multi-access point deployment
and management technology. For more information on Single Point Setup, including
configuration steps, see the
and management technology. For more information on Single Point Setup, including
configuration steps, see the
on Cisco.com.
Requirements
•
Your computer must meet the recommended hardware and software requirements.
•
A computer with Browser support for:
-
Internet Explorer v7.0 or later
-
Chrome v5.0 or later
-
Firefox v3.0 or later
-
Safari v3.0 or later
Limitations
CSCty78355—The Cisco WAP321 and WAP121 devices do not support multicast traffic over
Work Group Bridge mode. This is a design limitation of the Wireless Ethernet in Work Group
Bridge. Work Group Bridge translates and maps an IP address to a MAC address in the WET
table, which works only for Unicast IP addresses.
Work Group Bridge mode. This is a design limitation of the Wireless Ethernet in Work Group
Bridge. Work Group Bridge translates and maps an IP address to a MAC address in the WET
table, which works only for Unicast IP addresses.
Resolved Issues
CSCtx68659—Bonjour does not operate at the very first bootup of the WAP321 device.