Cisco Cisco WAP321 Wireless-N Access Point with Single Point Setup 릴리즈 노트
2
Release Notes
Requirements
•
Your computer must meet the recommended hardware and software requirements.
•
A computer with Browser support for:
-
Internet Explorer v7.0 or later
-
Chrome v5.0 or later
-
Firefox v3.0 or later
-
Safari v3.0 or later
Limitations
CSCty78355—The Cisco WAP321 and WAP121 devices do not support multicast traffic over
Work Group Bridge mode. This is a design limitation of the Wireless Ethernet in Work Group
Bridge. Work Group Bridge translates and maps an IP address to a MAC address in the WET
table, which works only for Unicast IP addresses.
Work Group Bridge mode. This is a design limitation of the Wireless Ethernet in Work Group
Bridge. Work Group Bridge translates and maps an IP address to a MAC address in the WET
table, which works only for Unicast IP addresses.
Resolved Issues
CSCub46043—Untagged packets are treated as tagged packets on the VAP interface.
CSCue70448—Deleting an SNMP group (related with a user1) prevents the addition of any
other SNMP users unless user1 is first deleted.
other SNMP users unless user1 is first deleted.
CSCue74057—Problem with IPv6 Radius authentication.
CSCue51459—Unable to save redirect URL in captive portal instance.
CSCub45975—In a radio saturated environment, Work Group Bridge mode can take from
three to seven minutes to establish connectivity with the remote upstream access point.
three to seven minutes to establish connectivity with the remote upstream access point.