Cisco Cisco WAP131 Wireless-N Dual Radio Access Point with PoE 관리 매뉴얼

WDS Bridge

Cisco WAP131 and WAP351 Administration Guide

103

When operating bridging in the 802.11n 2.4 GHz band, set the Channel 
Bandwidth to 20 MHz, rather than the default 20/40 MHz. In the 2.4 GHz, 20/
40 MHz band, the operating bandwidth can change from 40 MHz to 20 MHz 
if any 20 MHz WAP devices are detected in the area. The mismatched 
channel bandwidth can cause the link to disconnect. See 

 (Basic 

Settings) for information on configuring these settings.

•

When using WDS, be sure to configure WDS on both WAP devices 
participating in the WDS link.

•

You can have only one WDS link between any pair of WAP devices. That is, 
a remote MAC address may appear only once on the WDS page for a 
particular WAP device.

Select Wireless > WDS Bridge.

In the Spanning Tree Mode field, check Enable to enable STP mode on the Cisco 
WAP131. 

When enabled, STP helps prevent switching loops. STP is recommended if you 
configure WDS links.

Click Save.

To configure the untagged VLAN for the Cisco WAP351:

Select Wireless > WDS Bridge.

Configure these parameters: 

•

Untagged VLAN—Enables or disables VLAN tagging. When enabled (the 
default), all traffic is tagged with a VLAN ID. 

By default, all traffic on the WAP device uses VLAN 1 as the default untagged 
VLAN. This setting means that all traffic is untagged until you disable the 
untagged VLAN, change the untagged traffic VLAN ID, or change the VLAN 
ID for a VAP or client using RADIUS.