Cisco Cisco WAP131 Wireless-N Dual Radio Access Point with PoE 관리 매뉴얼

Access Points

Cisco WAP131 and WAP351 Administration Guide

175

Use the Access Points page to enable or disable Single Point Setup on the WAP 
device, view the cluster members, and configure the location and cluster name for 
a member. You can also click the IP address of a member to configure and view 
data on that device.

To configure the location and name of an individual Single Point Setup cluster 
member:

Select Single Point Setup > Access Points.

Single Point Setup is disabled on the WAP device by default. When it is disabled, 
the Enable Single Point Setup button is visible. If Single Point Setup is enabled, 
the Disable Single Point Setup button is visible. You can edit the Single Point 
Setup settings only when Single Point Setup is disabled.

Icons on the right side of the page indicate whether Single Point Setup is enabled 
and, if it is, the number of the WAP devices that are currently joined in the cluster.

With Single Point Setup disabled, configure these parameters for each individual 
member of a Single Point Setup cluster: 

•

Location—Enter a description of where the WAP device is physically 
located, for example, Reception. The location field is optional.

•

Cluster Name—Enter the name of the cluster for the WAP device to join, for 
example Reception_Cluster. The cluster name is not sent to other WAP 
devices. You must configure the same name on each device that is a 
member. The cluster name must be unique for each Single Point Setup that 
you configure on the network. The default is ciscosb-cluster.

•

Clustering IP Version—Choose the IP version that the WAP devices in the 
cluster use to communicate with other members of the cluster. The default is 
IPv4.

WorkGroup Bridge