Cisco Cisco WAP131 Wireless-N Dual Radio Access Point with PoE 관리 매뉴얼

System Summary

Cisco WAP131 and WAP351 Administration Guide

21

•

Base MAC Address—The MAC address of the WAP device.

•

Host Name—A name assigned to the WAP device.

•

Power Source—The system may be powered by a power adapter, or may 
be receiving power over Ethernet (PoE) from a Power Sourcing Equipment 
(PSE).

•

PSE Status (For WAP351 Only)

-

Overload—Indicates that an attached Powered Device (PD) requires 
power from the WAP device that is exceeding the configured allocation 
any time during the connectivity.

-

Down—Indicates that there is no PD device connector or there is a 
malfunction.

-

Up—Indicates that PSE normally works on 802.3af mode.

•

PSE Power Consumption (For WAP351 Only)—The power allocation for 
the connected PD device.

•

Firmware Version (Active Image)—The firmware version number of the 
active image.

•

Firmware MD5 Checksum (Active Image)—The checksum for the active 
image.

•

Firmware Version (Non-active)—The firmware version number of the 
backup image.

•

Firmware MD5 Checksum (Non-active)—The checksum for the backup 
image.

•

System Uptime—The time that has elapsed since the last reboot.

•

System Time—The current system time.

The TCP/UDP Service table shows basic information about protocols and 
services operating on the WAP device, including: 

•

Service—The name of the service, if available.

•

Protocol—The underlying transport protocol that the service uses (TCP or 
UDP).

•

Local IP Address—The IP address, if any, of a remote device that is 
connected to this service on the WAP device. All indicates that any IP 
address on the device can use this service.