Cisco Cisco Aironet 1552WU Outdoor Access Point

ap1240AG#config terminal

Enter configuration commands, one per line. End with CTRL-Z.

ap1240AG(config)# dot1x credentials test

ap1240AG(config-dot1x-creden)#username Cisco

ap1240AG(config-dot1x-creden)#password Cisco

ap1240AG(config-dot1x-creden)#exit

ap1240AG(config)#

Credential profiles are applied to an interface or an SSID in the same way. 

You can also use interface fa0 to enter the Gigabit 
Ethernet configuration mode.

Beginning in the privileged EXEC mode, follow these steps to apply the credentials to the access point 
wired port:

The following example applies the credentials profile test to the access point Fast Ethernet port:

ap1240AG>enable

Password:xxxxxxx

ap1240AG#config terminal

Enter configuration commands, one per line. End with CTRL-Z.

ap1240AG(config)#interface Gig0

ap1240AG(config-if)#dot1x credentials test

ap1240AG(config-if)#end

ap1240AG#

If you have a repeater access point in your wireless network and are using the 802.1X supplicant on the 
root access point, you must apply the 802.1X supplicant credentials to the SSID the repeater uses to 
associate with and authenticate to the root access point. 

Beginning in the privileged EXEC mode, follow these steps to apply the credentials to an SSID used for 
the uplink:

Enter global configuration mode.

Enter the interface configuration mode for the access point 
Gigabit Ethernet port.

dot1x credentials profile name

Enter the name of a previously created credentials profile.

Return to the privileged EXEC mode

(Optional) Save your entries in the configuration file.