Cisco Cisco WAP551 Wireless-N Single Radio Selectable Band Access Point 관리 매뉴얼
Single Point Setup
Access Points
Cisco Small Business WAP551 and WAP561 Wireless-N Access Point
158
10
The cluster name is not sent to other WAP devices. You must configure the same name
on each device that is a member. The cluster name must be unique for each Single Point
Setup you configure on the network. The default is ciscosb-cluster.
on each device that is a member. The cluster name must be unique for each Single Point
Setup you configure on the network. The default is ciscosb-cluster.
•
Cluster Priority—Enter the priority of the cluster for Dominant AP (Cluster Controller)
election.
election.
The higher number indicates the higher preference for this AP to become the Dominant
AP. In case of tie, lowest MAC address becomes dominant. Range: 0 to 255. Default
value is 0.
AP. In case of tie, lowest MAC address becomes dominant. Range: 0 to 255. Default
value is 0.
•
Clustering IP Version—Specify the IP version that the WAP devices in the cluster use
to communicate with other members of the cluster. The default is IPv4.
to communicate with other members of the cluster. The default is IPv4.
If you choose IPv6, Single Point Setup can use the link local address, autoconfigured
IPv6 global address, and statically configured IPv6 global address. Ensure that when
using IPv6, all the WAP devices in the cluster either use link-local addresses only or use
global addresses only.
IPv6 global address, and statically configured IPv6 global address. Ensure that when
using IPv6, all the WAP devices in the cluster either use link-local addresses only or use
global addresses only.
Single Point Setup works only with devices using the same type of IP addressing. It does
not work with a group of WAP devices where some have IPv4 addresses and some have
IPv6 addresses.
not work with a group of WAP devices where some have IPv4 addresses and some have
IPv6 addresses.
STEP 3
Click Enable Single Point Setup.