Cisco Cisco WAP571 Wireless-AC N Premium Dual Radio Access Point with PoE 설치 가이드

If it fails, you should get a reply similar to the following:

Pinging 192.0.2.10 with 32 bytes of data:
Request timed out.

• Complete the Setup Wizard. The Wi-Fi radio on the device is turned off 

by default, and the Setup Wizard activates it. For users who do not wish 
to use the Setup Wizard, log into the device using a Category 5e 
Ethernet cable, and activate the Wi-Fi radio manually. See the 
Administration Guide for details on activating the Wi-Fi radio.

• Power up the switch and your computer if they are turned off.

• Make sure your PoE switch is powered on and the lights indicate that 

you have a link. See 

• Verify that the devices on your network are not plugged into a 

switchable outlet.

• Check the state of the indicator lights. See 

• Check the Ethernet cable to ensure that it is firmly connected to your 

devices. Devices connected by the Ethernet cable can include the WAP 
device, and routers, any switches, and your computer.

• Verify the connected switch has auto-negotiation enabled. The access 

point and the switch need the same negotiation parameters set.

After a new firmware installation, if the Power light is flashing quickly, 
contact system support; see 

.

The most likely cause of connectivity failure is an incorrect IP address. The 
Web browser may be pointed to the wrong IP address, or your computer 
may be configured with an IP address that is not in the same subnet as the 
device.