Cisco Cisco WAP571 Wireless-AC N Premium Dual Radio Access Point with PoE 관리 매뉴얼

Wireless

WPS Process

Cisco Small Business WAP551 and WAP561 Wireless-N Access Point

103

STEP 4

Within two minutes, enter the WAP pin on the software interface of the client
device. The WAP pin is configured on the

WPS Setup

page.

When you enter the PIN on the client device, the WPS Operational Status changes
to Adding Enrollee. When the enrollment process is complete, the WPS
Operational Status changes to Ready and the Transaction Status changes to
Success.

When the client is enrolled, either the built-in registrar of the WAP device or the
external registrar on the network proceeds to configure the client with the SSID,
encryption mode, and public shared key of a WPS-enabled BSS.

CAUTION

This enrollment sequence may also work in reverse; that is, you may be able to
initiate the process on the client station by entering the pin of the WAP device.
However, this method is not recommended for security reasons, as it enables the
client to configure the SSID and security settings on the AP. The administrator
should only share the PIN with trusted devices.

To enroll a client station using the push button method:

STEP 1

Click Start next to PBC Enrollment.

STEP 2

Push the hardware button on the client station.

NOTE

You can alternatively initiate this process on the client station and then click the PBC
Enrollment Start button on the WAP device.

When you push the button on the client station, the WPS Operational Status
changes to Adding Enrollee. When the enrollment process is complete, the WPS
Operational Status changes to Ready and the Transaction Status changes to
Success.

The Instance Status section shows the following information about the WPS
instance selected in the WPS Instance ID list:

•

WPS Status—Whether the selected WPS instance is enabled or disabled.