Cisco Cisco WAP551 Wireless-N Single Radio Selectable Band Access Point 관리 매뉴얼
Administration
HTTP/HTTPS Service
Cisco Small Business WAP551 and WAP561 Wireless-N Access Point
35
3
HTTP/HTTPS Service
Use the HTTP/HTTPS Service page to enable and configure web-based
management connections. If HTTPS is used for secure management sessions, you
also use the HTTP/HTTPS Service page to manage the required SSL certificates.
management connections. If HTTPS is used for secure management sessions, you
also use the HTTP/HTTPS Service page to manage the required SSL certificates.
To configure HTTP and HTTP services:
STEP 1
Select Administration > HTTP/HTTPS Service in the navigation pane.
STEP 2
Configure these Global Settings:
•
Maximum Sessions—The number of web sessions, including both HTTP
and HTTPS, that can be in use at the same time.
and HTTPS, that can be in use at the same time.
When a user logs on to the WAP device configuration utility, a session is
created. This session is maintained until the user logs off or the Session
Timeout expires. The range is from 1 to 10 sessions. The default is 5. If the
maximum number of sessions is reached, the next user who attempts to log
on to the configuration utility receives an error message about the session
limit.
created. This session is maintained until the user logs off or the Session
Timeout expires. The range is from 1 to 10 sessions. The default is 5. If the
maximum number of sessions is reached, the next user who attempts to log
on to the configuration utility receives an error message about the session
limit.
•
Session Timeout—The maximum amount of time, in minutes, an inactive
user remains logged on to the WAP device configuration utility. When the
configured timeout is reached, the user is automatically logged off. The
range is from 1 to 60 minutes. The default is 10 minutes.
user remains logged on to the WAP device configuration utility. When the
configured timeout is reached, the user is automatically logged off. The
range is from 1 to 60 minutes. The default is 10 minutes.
STEP 3
Configure HTTP and HTTPS services:
•
HTTP Server—Enables access through HTTP. By default, HTTP access is
enabled. If you disable it, any current connections using that protocol are
disconnected.
enabled. If you disable it, any current connections using that protocol are
disconnected.
•
HTTP Port—The logical port number to use for HTTP connections, from
1025 to 65535. The default port number for HTTP connections is the well-
known IANA port number 80.
1025 to 65535. The default port number for HTTP connections is the well-
known IANA port number 80.
•
HTTPS Server—Enables access through secure HTTP. By default, HTTPS
access is enabled. If you disable it, any current connections using that
protocol are disconnected.
access is enabled. If you disable it, any current connections using that
protocol are disconnected.
•
HTTPS Port—The logical port number to use for HTTP connections, from
1025 to 65535. The default port number for HTTP connections is the well-
known IANA port number 443.
1025 to 65535. The default port number for HTTP connections is the well-
known IANA port number 443.