Cisco Cisco WAP571 Wireless-AC N Premium Dual Radio Access Point with PoE 관리 매뉴얼

Using the Access Point Setup Wizard

Cisco WAP571/E Administration Guide

10

then select Add. Add the intranet address of the Access Point (http://<ip-
address>) to the local intranet zone. The IP address can also be specified 
as the subnet IP address, so that all addresses in the subnet are added to 
the local intranet zone.

•

If you have multiple IPv6 interfaces on your management station, use the 
IPv6 global address instead of the IPv6 local address to access the Access 
Point from your browser.

By default, the web-based AP configuration utility logs out after 10 minutes of 
inactivity. See 

 for instructions on changing the default 

timeout period.

To log out, click Logout in the top right corner of the web-based AP configuration 
utility.

The first time that you log into the Access Point (or after it has been reset to the 
factory default settings), the Access Point Setup Wizard appears to help you 
perform initial configurations. Follow these steps to complete the wizard:

You must log in again after changing your password.

Click Next on the Welcome page of the Wizard. The Configure Device - IP 
Address window appears.

Click

 

Dynamic IP Address (DHCP) if you want the WAP device to receive an IP 

address from a DHCP server. You can also select Static IP Address to configure 
the IP Address manually. For a description of these fields, see 

Click Next. The Single Point Setup-Set a Cluster window appears. For a 
description of Single Point Setup, see 

.

To create a new Single Point Setup of WAP devices, select Create a New Cluster 
and specify a New Cluster Name. When you configure your devices with the 
same cluster name and enable Single Point Setup mode on other WAP devices, 
they automatically join the group.