Cisco Cisco WAP571 Wireless-AC N Premium Dual Radio Access Point with PoE 관리 매뉴얼
SNMP
Targets
Cisco WAP571/E Administration Guide
153
10
Targets
SNMPv3 targets send SNMP notifications using Inform messages to the SNMP
Manager. For SNMPv3 targets, only Informs are sent, not traps. For SNMP versions
1 and 2, traps are sent. Each target is defined with a target IP address, UDP port,
and SNMPv3 user name.
Manager. For SNMPv3 targets, only Informs are sent, not traps. For SNMP versions
1 and 2, traps are sent. Each target is defined with a target IP address, UDP port,
and SNMPv3 user name.
NOTE
SNMPv3 user configuration (see the
page) should be completed before
configuring SNMPv3 targets.
NOTE
The AP supports a maximum of eight targets.
To add SNMP targets:
STEP 1
Select SNMP > Targets in the navigation pane.
STEP 2
Click Add. A new row is created in the table.
STEP 3
Check the box in the new row and click Edit.
STEP 4
Configure the parameters:
•
IP Address—Enter the IPv4 address of the remote SNMP manager to
receive the target.
receive the target.
•
UDP Port—Enter the UDP port to use for sending SNMPv3 targets.
•
Users—Enter the name of the SNMP user to associate with the target. To
configure SNMP users, see the
configure SNMP users, see the
STEP 5
Click Save. The user is added to the SNMPv3 Targets list and your changes are
saved to the Startup Configuration.
saved to the Startup Configuration.
NOTE
To remove an SNMP target, select the user in the list and click Delete.