Cisco Cisco WAP571 Wireless-AC N Premium Dual Radio Access Point with PoE 관리 매뉴얼

Access Points

Cisco WAP571/E Administration Guide

174

The Access Points page allows you to enable or disable Single Point Setup on a 
WAP device, view the cluster members, and configure the location and cluster 
name for a member. You can also click the IP address of a member to configure 
and view data on that device.

To configure the location and name of an individual Single Point Setup cluster 
member:

Select Single Point Setup > Access Points in the navigation pane. 

Single Point Setup is disabled by default on the AP. When disabled, the Enable 
Single Point Setup button is visible. If Single Point Setup is enabled, the Disable 
Single Point Setup button is visible. You can edit Single Point Setup options only 
when Single Point Setup is disabled. 

Icons on the right side of the page indicate whether Single Point Setup is enabled 
and, if it is, the number of WAP devices that are currently joined in the cluster. 

With Single Point Setup disabled, configure the following information for each 
individual member of a Single Point Setup cluster. 

•

Location—Enter a description of where the access point is physically 
located, for example, Reception. The location field is optional.

•

Cluster Name—Enter the name of the cluster for the WAP device to join, for 
example Reception_Cluster. 

Bandwidth Utilization

Port Settings

Bonjour

VLAN and IPv4

IPv6 Address 

WDS Bridge

IPv6 Tunnel

Packet Capture

WorkGroup Bridge