Cisco Cisco WAP571E Wireless-AC N Premium Dual Radio Outdoor Access Point 관리 매뉴얼

Bridge

Cisco WAP571/E Administration Guide

107

The devices connected to the wired interface of the WAP device, can access the 
network connected by the infrastructure client interface. 

Before you configure WorkGroup Bridge on the WAP device, note these 
guidelines:

•

All WAP devices participating in WorkGroup Bridge must have the following 
identical settings:

-

Radio 

-

IEEE 802.11 Mode

-

Channel Bandwidth 

-

Channel (Auto is not recommended) 

See 

 (Basic Settings) for information on configuring these settings.

•

WorkGroup Bridge mode currently supports only IPv4 traffic.

•

WorkGroup Bridge mode is not supported across a Single Point Setup.

To configure WorkGroup Bridge mode:

Select Wireless > Bridge in the navigation pane.

Select the WorkGroup Bridge Mode from the drop-down selection. 

Select Enable for the WorkGroup Bridge Mode.

Select the radio interface on which to configure WorkGroup Bridge mode (Radio 1 
or Radio 2). 

Configure these parameters for the Infrastructure Client Interface (upstream):

•

SSID—The SSID of the BSS. 

There is an arrow next to SSID for SSID Scanning; this feature is disabled by 

default, and is enabled only if AP Detection is enabled in Rogue AP Detection 
(which is also disabled by default). 

•

Security—The type of security to use for authenticating as a client station 
on the upstream WAP device. Choices are:

-

-

-