Cisco Cisco Aironet 1200 Access Point 릴리즈 노트

Release Notes for Cisco Aironet Access Points for Cisco IOS Release 12.3(8)JEB

OL-11737-01

System Requirements

Figure 1

Network Interfaces: Radio Settings Page

Step 2

Select Disable to disable the radio.

Step 3

Click Apply at the bottom of the page.

Step 4

If your access point has two radios, repeat these steps for the second radio.

Beginning in privileged EXEC mode, follow these steps to disable the access point radios using the CLI:

If your access point has two radios, repeat these steps for the second radio. Use the no form of the
shutdown command to enable the radio.

Converting to Cisco IOS Software

If your 1200 series access point does not run IOS software, you can use the conversion utility or the
conversion upgrade image to convert the access point system to IOS software. Use the conversion utility
to maintain the current configuration after the conversion, or load the upgrade image to convert to IOS
software without saving the current configuration. Your 1200 series access point must be running one of
these VxWorks firmware versions before you can convert to IOS software:

•

VxWorks version 12.03T, 12.02T1, 12.01T1, 12.00T, 11.56, or 11.54T

The conversion upgrade image for 1200 series access points installs Cisco IOS Release 12.2(13)JA2 on
your 1200 series access point.

Command

Purpose

Step 1

configure terminal

Enter global configuration mode.

Step 2

interface dot11radio {0 | 1}

Enter interface configuration mode for the radio interface. The
2.4-GHz radio is radio 0, and the 5-GHz radio is radio 1.

Step 3

shutdown

Disable the radio port.

Step 4

end

Return to privileged EXEC mode.

Step 5

copy running-config startup-config (Optional) Save your entries in the configuration file.