Cisco Cisco Aironet 1250 Series Access Point 설치 가이드
10
78-17692-02
Installing the Power Injector
To install the power injector, follow these steps:
Step 1
Plug a Category-5 Ethernet cable into the port on the power injector
labeled To AP.
labeled To AP.
Step 2
Plug the other end of the Ethernet cable into the Ethernet Port on the
access point.
access point.
Step 3
Plug a Category-5 Ethernet cable into the port on the power injector
labeled To Switch.
labeled To Switch.
Step 4
Plug the other end of the Ethernet cable into your 10/100/1000
Ethernet switch, hub, or network.
Ethernet switch, hub, or network.
Step 5
Connect the female end of the supplied AC line cord into the AC
receptacle on the power injector.
receptacle on the power injector.
Step 6
Connect the other end of the line cord into an approved AC power
source.
source.
Step 7
Secure the power injector by mounting it to a vertical or horizontal
surface using tie-wraps or using the keyhole mounting holes on the
back of the unit.
surface using tie-wraps or using the keyhole mounting holes on the
back of the unit.