Cisco Cisco Aironet 1200 Access Point 릴리즈 노트
19
Release Notes for Cisco Aironet Access Points and Bridges for Cisco IOS Release 12.4(10b)JA4
OL-17693-01
Caveats
Pings and Link Tests Sometimes Fail to Clients with Both Wired and Wireless
Network Connections
Network Connections
When you ping or run a link test from an access point to a client device installed in a PC running
Microsoft Windows 2000, the ping or link test sometimes fails when the client has both wired and
wireless connections to the LAN. Microsoft does not recommend this configuration. For more
information, refer to Microsoft Knowledge Base article 157025 at this URL:
Microsoft Windows 2000, the ping or link test sometimes fails when the client has both wired and
wireless connections to the LAN. Microsoft does not recommend this configuration. For more
information, refer to Microsoft Knowledge Base article 157025 at this URL:
Layer 3 Mobility Not Supported on Repeaters and Workgroup Bridges
Repeater access points and workgroup bridges cannot associate to an SSID configured for Layer 3
mobility. Layer 3 mobility is not supported on repeaters and workgroup bridges.
mobility. Layer 3 mobility is not supported on repeaters and workgroup bridges.
WLSM Required for Layer 3 Mobility
You must use a Wireless LAN Services Module (WLSM) as your WDS device in order to properly
configure Layer 3 mobility. If you enable Layer 3 mobility for an SSID and your WDS device does not
support Layer 3 mobility, client devices cannot associate using that SSID.
configure Layer 3 mobility. If you enable Layer 3 mobility for an SSID and your WDS device does not
support Layer 3 mobility, client devices cannot associate using that SSID.
Caveats
This section lists open and resolved caveats for access points and bridges in Cisco IOS Release
12.4(10b)JA4.
12.4(10b)JA4.
Open Caveats
These caveats are open in Cisco IOS Release 12.4(10b)JA4:
•
CSCsv36602—Files appearing on access point flash with 5-GHz serial number as filename
These files are created when radar is detected on a DFS channel. The files are created with the
filename consisting of the serial number of the radio that detected the radar and include the DFS
channel on which the radar was detected. The file is used is used when the access point is reset to
ensure that the radar detected channels are not immediately selected after the reset.
filename consisting of the serial number of the radio that detected the radar and include the DFS
channel on which the radar was detected. The file is used is used when the access point is reset to
ensure that the radar detected channels are not immediately selected after the reset.
Conditions: When radar is detected on a DFS channel.
Workaround: None. This is an expected behavior. The file should not be removed.
•
CSCsk80813—Vista's anonymous provisioning does not work with access point local AAA server
•
CSCsm24495—Configuration change for adding data rate does not reflect in running config
•
CSCsm31801—TKIP+ WPAV2+CCKM does not work
When combination of authentication key-management WPA version 2 CCKM + encryption mode
ciphers TKIP is configured, an association failure occurs.
ciphers TKIP is configured, an association failure occurs.
Workaround—None.