Cisco Cisco Prime Network 3.10 설치 가이드
20
Figure 5
Unit Properties Dialog
Verify the Unit Installation
Follow the steps below to verify that the unit was installed properly. If there are any problems, rerun the installation.
Step 1
Open a Telnet or SSH session to the unit and log in as the user root.
Step 2
Check the status of all processes and daemons by entering the following command:
status
The output shows the status of each process and the number of exceptions found in the total number of log file lines
for that process. For example, [OK 0/39] means 0 exceptions found in the 39 log file lines that were checked.
for that process. For example, [OK 0/39] means 0 exceptions found in the 39 log file lines that were checked.
Step 3
In the ~/Main directory, confirm that:
a.
The scheme subdirectory exists and contains the correct scheme files.
b.
The scripts and UNIX subdirectories were created correctly.
c.
The registry directory exists and contains the necessary files.
Step 4
Check that the golden source was configured correctly on the server:
a.
Open the ~/Main/registry/avm99.xml file.
b.
Confirm that the file contains an entry for the key parent, which is the value of the IP address of the gateway.