Cisco Cisco 7815I Media Convergence Server 문제 해결 가이드
1727 - Slot x Drive Array-
New Logical Drive(s) Attachment
Detected. If more than 32
logical drives, this message
will be followed by:
Auto-configuration failed:
Too many logical drives.
New Logical Drive(s) Attachment
Detected. If more than 32
logical drives, this message
will be followed by:
Auto-configuration failed:
Too many logical drives.
None
was attached
when the
power drive
configuration
information
has been
updated to
add the new
logical
drives. The
maximum
number of
logical drives
supported is
32.
Additional
logical drives
are not added
to the
configuration.
when the
power drive
configuration
information
has been
updated to
add the new
logical
drives. The
maximum
number of
logical drives
supported is
32.
Additional
logical drives
are not added
to the
configuration.
Press F1 to
resume.
resume.
1729 - Disk consistency
initialization
in progress RAID 4/5
performance may be lower
until Auto Reliability
Monitoring has completed
automatic parity consistency
initialization.
initialization
in progress RAID 4/5
performance may be lower
until Auto Reliability
Monitoring has completed
automatic parity consistency
initialization.
None
Normal
operation.
operation.
This message
is normal
following the
initial
configuration
of RAID 4 or
RAID 5 logical
drives. This
POST message
goes away and
performance of
the controller
improves after
the parity data
is initialized by
ARM (an
automatic
process that
runs in the
background on
the controller).
is normal
following the
initial
configuration
of RAID 4 or
RAID 5 logical
drives. This
POST message
goes away and
performance of
the controller
improves after
the parity data
is initialized by
ARM (an
automatic
process that
runs in the
background on
the controller).
1730 - Fixed Disk 0 does not
support DMA Mode.
support DMA Mode.
None
Hard drive
error.
error.
Run the
System
Configuration
Utility and
correct.
System
Configuration
Utility and
correct.
1731 - Fixed Disk 1 does not
None
Hard drive
Run the
System
Configuration
System
Configuration
Page 11 of 13
Cisco - Cisco MCS-78XX Boot Error Codes
10/2/2008
http://kbase.cisco.com/paws/servlet/ViewFile/12138/mcs_boot.xml?convertPaths=1