Cisco Cisco D9824 Advanced Multi Decryption Receiver 설치 가이드
Setup Menu
OL-29015-01
113
Setting
Mode Options
Description
Default
DIT
Pass, Drop
Discontinuity
Information Table
Information Table
Pass
SIT
Pass, Drop
Selection Information
Table
Table
Pass
ECM
Pass, Drop
Entitlement Control
Message
Message
Pass
EMM
Pass, Drop
Entitlement Management
Message
Message
Pass
DRT
Pass, Drop
Disaster Recovery Table Pass
CDT
Pass, Drop
Code Download Table
Pass
Note: The CDT is different from the other tables listed because the CDT is referred to within
the PMT, rather than outside the PMT. Select Pass to permit the output of CDTs following
the configured DPM PID map configuration and all other DPM constraints. If a DPM PID
map has not been configured for the CDT PID and the PE Act is set to Map, the CDT will still
not output. Select Drop to override the DPM PID map configuration for CDT PIDs and to
always drop all CDTs.
the PMT, rather than outside the PMT. Select Pass to permit the output of CDTs following
the configured DPM PID map configuration and all other DPM constraints. If a DPM PID
map has not been configured for the CDT PID and the PE Act is set to Map, the CDT will still
not output. Select Drop to override the DPM PID map configuration for CDT PIDs and to
always drop all CDTs.
Setting Up Digital Program Mapping (DPM)
1 Verify that you are receiving a valid signal and that you have set up the channels
1 Verify that you are receiving a valid signal and that you have set up the channels
that you want to pass, drop or map.
2 Go to the Setup: Outputs, TS Out: DPM: Global menu and select Resync All for
the selected ASI output. This copies the input services PIDs to the remapped
output service PIDs.
output service PIDs.
3 Go to Setup: Outputs: TS Out: DPM: ASI, and select the PE containing the
channel you want to configure.
4 Set the Act for the selected PMT to either Pass, Drop, or Map depending on the
action desired.
A program can be set to one of three output modes, either Drop, Pass or Map.
A program can be set to one of three output modes, either Drop, Pass or Map.
LCD Setting
Description
Drop
Removes the service and its associated PMT reference
from the transport output.
from the transport output.
Pass
Permits the source content and PMT reference to
appear in the transport output with the same
references.
appear in the transport output with the same
references.
Map
Provides the flexibility to define all the outgoing PID
numbers for the PE, including those not currently on
transmission.
numbers for the PE, including those not currently on
transmission.
5 Use the RIGHT arrow key to move to the right and select PID to display the
detailed menu level.